P4 2.4'C' , 1GB OCZ DDR400 , Asus GF4/4800SE VIVO

Joined
Jan 27, 2002
Messages
895
Location
melb.vic.au
All this gear has been well cared for and is as new.
  • P4 2.4C. does 3.2 @ 1.55v. Can't tell how high this CPU clocks as I've never pushed it any harder. Core temps have never been over 40C. Comes boxed, with unused Intel HSF.
    - Purchased one month ago (17/6/03)
    - Reason for sale: upgraded to faster CPU
    - Reserve: AU$260
    - Current highest bid:
  • 1GB (2 x 512MB) OCZ Basic Series DDR400. Black heat spreaders. SPD timings are 2.5-4-4 however I have successfully run this RAM at 2-3-3-6/210MHz on my Asus P4P800 and 2-3-3-6/200MHz on my Soltek nForce2 mobo. at 210Mhz on the nForce2 I had to change timings to 2-3-3-7. Highest speed tested was 217MHz at 2.5-3-4-7 timings on nForce2 board. May go higher but the Athlon wouldn't. Always run in dual channel setup. Note: RAM has never had more than 2.65V through it, and only then it was for short time, when benchmarking.
    - Purchased 3.5 months ago (06/04/03)
    - Reason for sale: upgraded to faster RAM
    - Reserve: AU$300
    - Current highest bid:
  • Asus V9480 VTD G4 Ti4800SE-8X 128Mo ViVo. Never used.
    - Purchased 3 days ago (14/7/03)
    - Reason for sale: Impulse purchase. Decided to go with a 9800Pro instead so now not needed.
    - Reserve: AU$200
    - Current highest bid:
Buyer pays postage. Please post all questions, bids, comments in this thread. Thanks and happy bidding!
 
I've only just got the system up and running and have set the FSB:Mem ratio to 5:4. timimgs are 2-2-2-5 @ 2.55V. I'm waiting for the Shin-Etsu thermal paste to cure before I start pushing limits. when everything is settled in properly, the plan is to up the FSB:Mem ratio to 1:1 and run this RAM at 2.5-4-4-8 @ 250MHz with 2.65-2.75V. if I'm lucky I can go higher again.
 
Back
Top