Different case from Lian li
- Thread starter Bozo
- Start date
CougTek
Hairy Aussie
It supports very large motherboards like the Gigabyte oversized board SSDdrueding wanted to use. The CPU cooler height must be limited though. And the front USB connector has to be plug uinto one of the rear ports :tdown: But overall, it's an interesting take on computer case design.
time
0
I disagree, Lunar. Apart from hotswap bays, that arrangement looks far easier to change drives - especially 2.5" drives.
CougTek, you're mistaken; the USB 3.0 ports end in a 20-pin header plug:
CougTek, you're mistaken; the USB 3.0 ports end in a 20-pin header plug:
I like it, I might have chosen it over the one I got.
CougTek
Hairy Aussie
That's the image (from Lian Li's site) that made me write the comment regarding the USB 3 port. Look at the blue internal USB port close to the front panel's interior :
time
0
Hmmm, interesting. I wonder what's actually shipping? Probably the 20-pin header, because the review is dated 30th August 2011.
Here's the review. The first picture shows the case with a 20-pin header plug attached.
Here's the review. The first picture shows the case with a 20-pin header plug attached.
Bozo
0
According to the review, the front USB ports are 3.0. The adaptor cable allows them to be connected to USB 2.0 if your motherboard does not support USB 3.0
Mercutio
Fatwah on Western Digital
I like the drive tray. It needs more of them, though. Or maybe I just need to break down and trade all my computer chassis for Norco monstrosities.
Bozo
0
Maybe you could mount drives on both sides of the tray?
2.5" on one side, 3.5" on the other.
2.5" on one side, 3.5" on the other.
CougTek
Hairy Aussie
That's how it is intended to be used, with the 2.5" drive mounted on the inside. A case that can harbour 6 3TB 3.5" drives plus 6 1TB 2.5" drives isn't too bad IMO. It might not be like a Norco with 24 bays, but it's better than most enclosures of comparable size.